Supermicro 747TG-R1400B-SQ Manuel d'utilisateur télécharger pdf (Page 32)

SC747TG Chassis Manual

5-18

5-19

Chapter 5: Chassis Setup and Maintenance

Installing the Motherboard

Installing the Motherboard into the Chassis

1. Review the documentation that came with your motherboard. Become familiar

with component placement, requirements, and precautions.

2. Disconnect the power supply and lay the chassis on a at surface.

3. Open the chassis cover.

4. As required by your motherboard, install standoffs in any areas that do not

have a permanent standoff. To do this:

A. Place a hexagonal standoff screw through the bottom the chassis.

B. Secure the screw with the hexagon nut (rounded side up).

5. Lay the motherboard on the chassis aligning the permanent and optional

standoffs.

6. Secure the motherboard to the chassis using the rounded, Phillips head

screws. Do not exceed more than eight pounds of torque per square inch

when tightening down the motherboard.

7. Secure the CPU(s), heatsinks, and other components to the motherboard,

chassis, and/or backplane as needed.

Figure 5-20: Installing the Motherboard

Installing the Active Heatsink

Figure 5-21: Installing the Active Heatsink

Installation of the active heatsink will vary, depending upon the model of heatsink,

motherboard and CPU used in the system. For more details refer to the user manu-

als of these components.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 107 108

Pas de commentaire

Supermicro 747TG-R1400B-SQ Manuel d'utilisateur Page 32