Supermicro X8SIU-F Manuel d'utilisateur télécharger pdf (Page 61)

3-4

X8SIU-F User's Manual

web site. Select your motherboard model and download the BIOS (.rom) le to

your computer. Also, check the current BIOS revision and make sure that it is

newer than your BIOS before downloading. You may choose the zip le or the

.exe le. If you choose the zipped BIOS le, please unzip the BIOS le onto a

bootable device or a USB pen/thumb drive. To ash the BIOS, run the batch

le named "ami.bat" with the new BIOS .rom le from your bootable device or

USB pen/thumb drive. Use the following format:

F:\> ami xxxxxxxx.rom <Enter>

Notes: Be sure to insert a space after "ami" and always use the le named

“ami.bat” to update the BIOS.

When completed, your system will automatically reboot. If you choose the .exe

le, please run the .exe le under Windows to create the BIOS ash oppy disk.

Insert the oppy disk into the system you wish to ash the BIOS. Then, boot

the system to the oppy disk. The BIOS utility will automatically ash the BIOS

without any prompts. Please note that this process may take a few minutes to

complete. Do not be concerned if the screen is paused for a few minutes.

Warning: Do not shut down or reset the system while updating the BIOS to

prevent possible system boot failure!

When the BIOS ashing screen is completed, the system will reboot and will

show “Press F1 or F2”. At this point, you will need to load the BIOS defaults.

Press <F1> to go to the BIOS setup screen, and press <F9> to load the default

settings. Next, press <F10> to save and exit. The system will then reboot.

Note: The SPI BIOS chip installed on this motherboard is not removable. To

repair or replace a damaged BIOS chip, please send your motherboard to RMA

at Supermicro for service.

Question: I think my BIOS is corrupted. How can I recover my BIOS?

Answer: Please see Appendix C, BIOS Recovery for detailed instructions.

Question: What's on the CD that came with my motherboard?

Answer: The supplied compact disc has quite a few drivers and programs

that will greatly enhance your system. We recommend that you review the CD

and install the applications you need. Applications on the CD include chipset

drivers for Windows, security and audio drivers.

Question: How do I solve an error message “IASTOR.SYS read error” when

installing Windows and "press F6 to install Intel RAID driver" on my X8SIU-

F motherboard?

Answer: To solve this issue, disable the IPMI jumper. Another solution is to

use a USB oppy drive instead of the onboard oppy drive. For the IPMI jumper

location, please check Chapter 1.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 97 98

Pas de commentaire

Supermicro X8SIU-F Manuel d'utilisateur Page 61