Supermicro SBA-7142G-T4 Manuel d'utilisateur télécharger pdf (Page 68)

SBA-7142G-T4 Blade Module User’s Manual

A-2

Previous boot incomplete - Default

configuration used

Previous POST did not complete successfully. POST loads

default values and offers to run Setup. If the failure was caused

by incorrect values and they are not corrected, the next boot

will likely fail. On systems with control of wait states, improper

Setup settings can also terminate POST and cause this error

on the next boot. Run Setup and verify that the waitstate

configuration is correct. This error is cleared the next time the

system is booted.

Memory Size found by POST differed

from CMOS

Memory size found by POST differed from CMOS.

Diskette drive A error

Diskette drive B error

Drive A: or B: is present but fails the BIOS POST diskette tests.

Check to see that the drive is defined with the proper diskette

type in Setup and that the diskette drive is attached correctly.

Incorrect Drive A type - run SETUP Type of floppy drive A: not correctly identified in Setup.

Incorrect Drive B type - run SETUP Type of floppy drive B: not correctly identified in Setup.

System cache error - Cache disabled

RAM cache failed and BIOS disabled the cache. On older

boards, check the cache jumpers. You may have to replace the

cache. See your dealer. A disabled cache slows system

performance considerably.

CPU ID: CPU socket number for Multi-Processor error.

EISA CMOS not writeable ServerBIOS2 test error: Cannot write to EISA CMOS.

DMA Test Failed

ServerBIOS2 test error: Cannot write to extended DMA (Direct

Memory Access) registers.

Software NMI Failed

ServerBIOS2 test error: Cannot generate software NMI

(Non-Maskable Interrupt).

Fail-Safe Timer NMI Failed ServerBIOS2 test error: Fail-Safe Timer takes too long.

device Address Conflict Address conflict for specified device.

Allocation Error for: device

Run ISA or EISA Configuration Utility to resolve resource

conflict for the specified device.

CD ROM Drive CD ROM Drive identified.

Entering SETUP... Starting Setup program

Failing Bits: nnnn

The hex number nnnn is a map of the bits at the RAM address

which failed the memory test. Each 1 (one) in the map

indicates a failed bit. See errors 230, 231, or 232 above for

offset address of the failure in System, Extended, or Shadow

memory.

Fixed Disk n Fixed disk n (0-3) identified.

Invalid System Configuration Data Problem with NVRAM (CMOS) data.

I/O device IRQ conflict I/O device IRQ conflict error.

PS/2 Mouse Boot Summary Screen: PS/2 Mouse installed.

Table A-1. BIOS POST Messages (Continued)

BIOS Message Description

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 79 80

Commentaires sur ces manuels

Pas de commentaire

Supermicro SBA-7142G-T4 Manuel d'utilisateur Page 68

Commentaires sur ces manuels