Supermicro CSE-513L-260-B Guide de l'utilisateur télécharger pdf (Page 18)

2-8

SC513 Chassis User’s Guide

E. Installing the Motherboard

Be sure to disconnect the power supply before accessing or installing the mother-

board into the chassis. (Refer to Chapter 1 for Safety Guidelines.)

Procedures

1. Lay the chassis on a flat surface.

2. Locate the CPU location(s). If you have a UP system, be sure to install heatsink

brackets on the reverse side of the CPU. (If you have a DP system, please ignore

this step because the heatsink brackets are pre-installed by the manufacturer.)

3. Lay the motherboard on the standoffs, and secure the motherboard (and Mylar

sheets if any) to the chassis with type A screws. (*Refer to Page 2-1 MB kit for

the Type A screw.)

4. Secure CPU heatsink(s) to the motherboard. (*Refer to the next section for

heatsink installation.)

5. Install the air shroud(s) on the motherboard by inserting air shroud clips into

the corresponding holes.

(**Note: the CPU, heatsinks and the motherboard shown above are for

reference only!! Both items are not included in the SC513 shipping package.)

UP Systems

DP Systems

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Pas de commentaire

Supermicro CSE-513L-260-B Guide de l'utilisateur Page 18