Supermicro SYS-5038A-IL Manuel d'utilisateur télécharger pdf (Page 100)

7-18

SuperWorkstation 5038A-IL User's Manual

If the item above - SATA Mode Select is set to IDE, the following items are

displayed:

Serial ATA Port 0~ Port 5

This item displays the information detected on the installed SATA drives on the

particular SATA port.

• Model number of drive and capacity

• Software Preserve Support

If the item above - SATA Mode Select is set to RAID, the following items are

displayed:

Serial ATA Port 0~ Port 5

This item displays the information detected on the installed SATA drives on the

particular SATA port.

• Model number of drive and capacity

• Software Preserve Support

Port 0 ~ Port 5 Hot Plug

This feature designates this port for hot plugging. Set this item to Enabled for

hot-plugging support, which will allow the user to replace a SATA drive without

shutting down the system. The options are Enabled and Disabled.

Port 0 ~ Port 1 SATA Device Type

This feature conﬁ gures the selected SATA port to support either a solid state

drive or hard disk drive. Set this item to Enabled to enable hot-plugging. The

options are Hard Disk Drive and Solid Sate Drive.

Port 0 ~ Port 5 Spin Up Device

On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-

SET initialization sequence to the device. The options are Enabled and Disabled.



PCIe/PCI/PnP Conﬁ guration

This feature allows the user to set the PCI/PnP conﬁ gurations for the following items:

Above 4G Decoding

Select Enabled for 64-bit devices to be decoded above the 4GB address space

If 64bit PCI decoding is supported by the system. The options are Disabled and

Enabled.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 121 122

Pas de commentaire

Supermicro SYS-5038A-IL Manuel d'utilisateur Page 100