Supermicro 2026TT-H6RF Manuel d'utilisateur télécharger pdf (Page 41)

Chapter 5: Advanced Serverboard Setup

5-5

Remove power from the system 1.

and unplug the AC power cord

from the power supply.

Do not apply any thermal grease 2.

to the heatsink or the CPU die;

the required amount has already

been applied.

Place the heatsink on top of the 3.

CPU so that the four mounting

holes are aligned with those

on the (preinstalled) heatsink

retention mechanism.

Screw in two diagonal screws (i.e. 4.

the #1 and the #2 screws) until

just snug. Do not fully tighten the

screws or you may damage the

CPU.)

Add the two remaining screws 5.

then ﬁ nish the installation by fully

tightening all four screws.

Installing a CPU Heatsink

Screw #1

Screw #2

Screw #1

Screw #2

Install Screw #1

Note: See Chapter 6 for details on installing the air shroud.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 105 106

Pas de commentaire

Supermicro 2026TT-H6RF Manuel d'utilisateur Page 41