Supermicro 5016I-T Manuel d'utilisateur Page 75
- Page / 98
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Chapter 7: BIOS
7-9
SATA#2 Confi guration (Available if IDE is enabled under "Confi gure SATA#1
as" above)
Selecting Enhanced will set SATA#2 to native SATA mode. The options are
Compatible and Enhanced
IDE Detect Timeout (sec)
Use this feature to set the time-out value for the BIOS to detect the ATA, ATAPI
devices installed in the system. The options are 0 (sec), 5, 10, 15, 20, 25, 30, and
35.
Primary IDE Master/Slave, Secondary IDE Master/Slave, Third IDE Master,
and Fourth IDE Master
These settings allow the user to set the parameters of Primary IDE Master/Slave,
Secondary IDE Master/Slave, Third and Fourth IDE Master slots. Hit <Enter> to
activate the following submenu screen for detailed options of these items. Set the
correct confi gurations accordingly. The items included in the submenu are:
Type
Select the type of device connected to the system. The options are Not Installed,
Auto, CD/DVD and ARMD.
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk drive.
In the LBA mode, the maximum drive capacity is 137 GB. For drive capacities
over 137 GB, your system must be equipped with a 48-bit LBA mode addressing.
If not, contact your manufacturer or install an ATA/133 IDE controller card that
supports 48-bit LBA mode. The options are Disabled and Auto.
Block (Multi-Sector Transfer)
Block Mode boosts the IDE drive performance by increasing the amount of data
transferred. Only 512 bytes of data can be transferred per interrupt if Block Mode
is not used. Block Mode allows transfers of up to 64 KB per interrupt. Select
Disabled to allow data to be transferred from and to the device one sector at
a time. Select Auto to allow data transfer from and to the device occur multiple
sectors at a time if the device supports it. The options are Auto and Disabled.
PIO Mode
The IDE PIO (Programmable I/O) Mode programs timing cycles between the
IDE drive and the programmable IDE controller. As the PIO mode increases, the
cycle time decreases. The options are Auto, 0, 1, 2, 3, and 4.
- SUPER 1
- Manual Revision 1.0 2
- Release Date: October 6, 2009 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 4 System Safety 7
- Chapter 7 BIOS 9
- Chapter 1 11
- Introduction 11
- 1-2 Motherboard Features 12
- 1-3 Chassis Features 13
- System Block Diagram 14
- 1-4 Contacting Supermicro 15
- Chapter 2 17
- Server Installation 17
- Warnings and Precautions! 18
- Rack Mounting Considerations 19
- Installing the Chassis Rails 21
- Installing the Rack Rails 21
- Chapter 3 27
- System Interface 27
- Overheat/Fan Fail 28
- Chapter 4 31
- System Safety 31
- 4-3 ESD Precautions 33
- LITHIUM BATTERY 34
- BATTERY HOLDER 34
- Chapter 5 35
- Advanced Motherboard Setup 35
- 5-2 Motherboard Installation 36
- 5-3 Connecting Cables 36
- Connecting Power Cables 37
- Connecting the Control Panel 37
- 5-4 I/O Ports 38
- Removing the Heatsink 42
- 5-6 Installing Memory 43
- Memory Population Guidelines 44
- REV:1.00 47
- 5-9 Connector Defi nitions 49
- 5-10 Jumper Settings 54
- 5-11 Onboard Indicators 56
- (I-SATA0 ~ I-SATA5) 57
- Chapter 6 59
- Advanced Chassis Setup 59
- 6-2 Control Panel 60
- 6-3 System Fans 61
- Accessing the Drive Bays 62
- Serial ATA Drive Installation 62
- DVD-ROM Drive Installation 64
- 6-5 Power Supply 65
- Chapter 7 67
- 7-2 Main Setup 68
- XBOOT Feature 70
- Processor & Clock Options 71
- Advanced Chipset Control 73
- SATA / Floppy Confi guration 74
- XPCI/PnP Confi guration 77
- XRemote Access Confi guration 79
- Hardware Health Confi guration 80
- XACPI Confi guration 82
- XEvent Log Confi guration 84
- 7-4 Security Settings 86
- 7-5 Boot Settings 87
- 7-6 Exit Options 88
- Appendix A 91
- POST Error Beep Codes 91
- Appendix B 93
- Installing Windows 93
- Appendix C 95
- System Specifi cations 95
Produits connexes et manuels pour Le serveur à l'état brut Supermicro 5016I-T
(104 pages)
(42 pages)Gai-tronics ACC2500 Audio Control Center manuales
Manuales del propietario y guías del usuario para Comunicación Gai-tronics ACC2500 Audio Control Center.
Ofrecemos 1 manuales en pdf Gai-tronics ACC2500 Audio Control Center para descargar gratis por tipos de documentos: Manual de usuario
Commentaires sur ces manuels