Supermicro SuperServer 7047R-TXRF Manuel d'utilisateur télécharger pdf (Page 71)

Chapter 6: Advanced Chassis Setup

6-11

Hard Drive

Hard Drive Tray

Figure 6-11. Adding a Hard Drive to the Drive Carrier

4. Place the hard drive to the hard drive tray. Make sure The hard drive can

be SAS or SATA depending on your serverboard. The hard drive may not

completely ll the tray. See Figure 6-11 for details.

5. Secure the hard drive to the carrier with four screws from the bottom.

6. Slide the hard drive into the chassis until the carrier clicks into place.

7. Repeat these steps for each hard drive carrier.

Warning: Except for short periods of time (swapping hard drives), do not

operate the server with the hard drive carriers removed.

Warning! Enterprise level hard disk drives are recommended for use in

Supermicro chassis and servers. For information on recommended HDDs,

visit the Supermicro Web site at http://www.supermicro.com/products/nfo/

storage.cfm.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 111 112

Pas de commentaire

Supermicro SuperServer 7047R-TXRF Manuel d'utilisateur Page 71