Supermicro CSE-747TQ-R1400B Manuel d'utilisateur télécharger pdf (Page 51)

6-1

Chapter 6: Rack Installation

Chapter 6

Rack Installation

6-1 Overview

This chapter provides a quick setup checklist to get your chassis up and running.

Following these steps in the order given should enable you to have the system

operational within a minimum amount of time.

6-2 Unpacking the System

You should inspect the box the chassis was shipped in and note if it was damaged

in any way. If the chassis itself shows damage you should le a damage claim

with the carrier who delivered it.

Decide on a suitable location for the rack unit that will hold your chassis. It should

be situated in a clean, dust-free area that is well ventilated. Avoid areas where

heat, electrical noise and electromagnetic elds are generated. You will also need

it placed near a grounded power outlet. Be sure to read the Rack and Server

Precautions in the next section.

6-3 Preparing for Setup

The box your chassis was shipped in should include two sets of rail assemblies,

two rail mounting brackets and the mounting screws you will need to install the

system into the rack. Please read this section in its entirety before you begin the

installation procedure outlined in the sections that follow.

Choosing a Setup Location

Leave enough clearance in front of the rack to enable you to open the front •

door completely (~25 inches).

Leave approximately 30 inches of clearance in the back of the rack to allow for •

sufcient airow and ease in servicing.

This product is for installation only in a Restricted Access Location (dedicated •

equipment rooms, service closets and the like).

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 79 80

Pas de commentaire

Supermicro CSE-747TQ-R1400B Manuel d'utilisateur Page 51