Supermicro X10DRH-I Manuel d'utilisateur Page 127
- Page / 131
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Appendix C: UEFI BIOS Recovery
C-1
Appendix C
UEFI BIOS Recovery Instructions
Warning: Do not upgrade the BIOS unless your system has a BIOS-related issue.
Flashing the wrong BIOS can cause irreparable damage to the system. In no event shall
Supermicro be liable for direct, indirect, special, incidental, or consequential damages
arising from a BIOS update. If you need to update the BIOS, do not shut down or reset
the system while the BIOS is updating to avoid possible boot failure.
C-1 An Overview to the UEFI BIOS
The Unied Extensible Firmware Interface (UEFI) provides a software-based in-
terface between the operating system and the platform rmware in the pre-boot
environment. The UEFI specication supports an architecture-independent mecha-
nism for add-on card initialization to allow the UEFI OS loader, which is stored in
the add-on card, to boot the system. The UEFI offers a clean, hands-off control to
a computer system at bootup.
C-2 How to Recover the UEFI BIOS Image (-the Main
BIOS Block)
A UEFI BIOS ash chip consists of a recovery BIOS block and a main BIOS block (a
main BIOS image). The boot block contains critical BIOS codes, including memory
detection and recovery codes for the user to ash a new BIOS image if the original
main BIOS image is corrupted. When the system power is on, the boot block codes
execute rst. Once it is completed, the main BIOS code will continue with system
initialization and bootup.
Note: Follow the BIOS recovery instructions below for BIOS recovery
when the main BIOS boot crashes. However, when the BIOS boot block
crashes, you will need to follow the procedures below for BIOS recovery.
C-3 To Recover the Main BIOS Block Using a USB-
Attached Device
This feature allows the user to recover a BIOS image using a USB-attached device
without additional utilities used. A USB ash device such as a USB Flash Drive, or
a USB CD/DVD ROM/RW device can be used for this purpose. However, a USB
Hard Disk drive cannot be used for BIOS recovery at this time.
- X10DRH-C 1
- X10DRH-CT 1
- X10DRH-i 1
- X10DRH-iT 1
- About This Motherboard 3
- Manual Organization 3
- Contacting Supermicro 5
- Table of Contents 6
- Chapter 1 9
- Overview 9
- X10DRH-C/i(T) 11
- X10DRH-C/i (T) 18
- 1-3 Special Features 20
- 1-5 ACPI Features 21
- 1-6 Power Supply 21
- Management Engine (ME) 22
- Chapter 2 23
- Installation 23
- Product Disposal 25
- Precautions 26
- Unpacking 26
- •Phillips screwdriver 27
- •Panhead screws (9 pieces) 27
- Installing the Motherboard 28
- OPEN 1st 29
- Direction of the 34
- CAUTION 35
- Removing Memory Modules 35
- Chapter 2: Installation 37
- L3-000099-00 Cable 39
- The Reverse Side 39
- 1. GLAN1 (X10DRH-C/i) 43
- 10GLAN1 (X10DRH-CT/iT) 43
- 2. GLAN2 (X10DRH-C/i) 43
- 10GLAN2 (X10DRH-CT/iT) 43
- 3. IPMI LAN 43
- Front Control Panel 45
- 2-8 Connecting Cables 50
- LAN CTRL 50
- 2-9 Jumper Settings 56
- A. VGA Enabled 58
- B. BMC Enabled 58
- A. SAS Enabled 60
- 2-10 Onboard LED Indicators 61
- A. PWR LED 62
- B. BMC LED 62
- A. SAS Activity 63
- B. SAS Fault 63
- A. SAS Heart 64
- 2-11 SATA/SAS Connections 65
- A. SAS0-3 66
- B. SAS4-7 66
- Chapter 3 67
- Troubleshooting 67
- No Video 68
- System Boot Failure 68
- Memory Errors 69
- •System conguration 71
- Proper Battery Disposal 72
- Battery Removal 72
- Chapter 4 75
- 4-2 Main Setup 76
- Boot Feature 78
- Power Conguration 79
- CPU Conguration 80
- (Conguration) 83
- Chipset Conguration 85
- North Bridge 85
- IIO Conguration 85
- IIO0 Conguration 85
- •PCI-E Port Link Status 86
- •PCI-E Port Link Max 86
- •PCI-E Port Link Speed 86
- IIO1 Conguration 89
- QPI General Conguration 93
- QPI Status 93
- Memory Conguration 94
- •P1 DIMMA1 95
- •P2 DIMME1 95
- •USB Module Version 96
- •USB Devices 96
- •Software Preserve 98
- PCIe/PCI/PnP Conguration 103
- Super IO Conguration 105
- Enabling TPM in the BIOS 111
- iSCSI Conguration 113
- Add an Attempt 113
- Delete Attempts 113
- Change Attempt Order 113
- ACPI Settings 113
- 4-4 Event Logs 114
- View SMBIOS Event Log 115
- 4-5 IPMI 116
- •IPMI LAN Selection 117
- •IPMI Network Link Status 117
- 4-6 Security Settings 118
- 4-7 Boot Settings 119
- •Boot Option #1 120
- •UEFI Boot Option #1 120
- Appendix A 123
- BIOS POST Error Beep Codes 123
- Appendix B 125
- B-2 Installing SuperDoctor5 126
- Appendix C 127
Produits connexes et manuels pour Cartes mères de serveurs/postes de travail Supermicro X10DRH-I
(117 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.272 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels