Supermicro CSE-825TQ-R720UB Manuel d'utilisateur télécharger pdf (Page 45)

5-23

Chapter 5: Chassis Setup and Maintenance

Replacing or Installing the DVD Drive

Replacing or Installing DVD Drives

Power down and unplug the system from the outlet.

Remove the chassis cover.

Disconnect the power and data cables from the drive to other chassis compo

nents including the motherboard and backplane.

Remove the old drive by depressing the release tab, then pulling the drive out

of the chassis.

Insert the new drive unit in the slot until the tab locks into place.

Connect the data and power cables to the backplane and motherboard.

For more information, see the manual for your backplane in the appendix

Replacing or Installing Floppy Drives

Power down and unplug the system

Remove the chassis cover.

Disconnect the power and data cables from the drive to other chassis compo

nents including the motherboard and backplane.

Remove the old drive by depressing the release tab, then pulling the drive out

of the chassis.

Insert the new drive unit in the slot until the tab locks into place.

Connect the data and power cables to the backplane and, if necessary,

motherboard.

For more information, see the manual for your backplane in the appendix.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 71 72

Pas de commentaire

Supermicro CSE-825TQ-R720UB Manuel d'utilisateur Page 45