Supermicro 2016Ti-HTRF Manuel d'utilisateur télécharger pdf (Page 43)

Chapter 5: Advanced Motherboard Setup

5-9

Figure 5-4. Removing the Heatsink

Screw #1

Motherboard

Loosen screws in the

sequence shown

Screw #2

Screw #3

Screw #4

5-6 Installing Memory

Note: Check the Supermicro web site for recommended memory modules.

CAUTION

Exercise extreme care when installing or removing DIMM

modules to prevent any possible damage.

DIMM Installation

Insert the desired number of DIMMs into the memory slots, starting with 1.

DIMM1A (slot 1, Channel A - see Figure A on the following page). Insert each

DIMM module vertically into its slot. Pay attention to the notch along the bot-

tom of the module to prevent incorrect DIMM module installation.

Gently press down on the DIMM module until it snaps into place in the slot. 2.

Repeat step 1 to install DIMM1B if needed.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 105 106

Pas de commentaire

Supermicro 2016Ti-HTRF Manuel d'utilisateur Page 43