Supermicro SuperServer 1027R-WC1R Manuel d'utilisateur télécharger pdf (Page 55)

Chapter 5: Advanced Serverboard Setup

5-7

Figure 5-3. Installing the Heatsinks

Figure 5-4. Securing a Heatsink

Note: be aware that the heatsink for CPU1 must be installed in the correct orien-

tation: the air tunnel must be on the right side when viewed from the front of the

system. (Above ﬁ gure shows heatsink viewed from the rear.)

Loosen screws

in sequence as

shown.

Screw #2

Screw #1

Screw #3

Screw #4

Air tunnel

2. Gently wriggle the heatsink to loosen it from the CPU (do not use excessive

force). Once the CPU is loose, remove the it from the CPU socket.

3. Clean the surface of the CPU and the heatsink to remove the used thermal

grease. Reapply the proper amount of thermal grease then re-install the CPU

and the heatsink.

SNK-P0047PSC (for CPU1)

SNK-P0047PS (for CPU2)

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 119 120

Pas de commentaire

Supermicro SuperServer 1027R-WC1R Manuel d'utilisateur Page 55