Supermicro SuperServer 1027R-WC1R Manuel d'utilisateur télécharger pdf (Page 82)

6-6

SUPERSERVER 1027R-WC1R/1027R-WC1RT User's Manual

4. Insert the drive carrier into its bay, keeping the carrier oriented so that the

hard drive is on the top of the carrier and the release button is on the right

side. When the carrier reaches the rear of the bay, the release handle will

retract.

5. Push the handle in until it clicks into its locked position

Figure 6-3. Installing a Drive into a Carrier

Removing a Hard Drive (Figure 6-4)

1. To remove a carrier, push the release button located beside the drive LEDs.

2. Swing the handle fully out and use it to pull the unit straight out.

Note: Your operating system must have RAID support to enable the hot-plug ca-

pability of the hard drives.

Caution: Regardless of how many hard drives are installed, all drive carriers must

remain in the drive bays to maintain proper airﬂ ow.

Enterprise level hard disk drives are recommended for use in Supermicro chassis

and servers. For information on recommended HDDs, visit the Supermicro Web site

at http://www.supermicro.com/products/nfo/ﬁ les/storage/SAS-CompList.pdf

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 119 120

Pas de commentaire

Supermicro SuperServer 1027R-WC1R Manuel d'utilisateur Page 82