Supermicro SuperServer 7036A-T Manuel d'utilisateur télécharger pdf (Page 41)

Chapter 5: Advanced Serverboard Setup

5-13

Reset Button

The Reset Button connection is

located on pins 3 and 4 of JF1 and

attaches to the reset switch on the

computer chassis. See the table on

the right for pin deﬁ nitions.

Power Button

The Power On connection is on pins

1 and 2 of JF1. These should be

connected to the chassis power but-

ton. See the table on the right for pin

deﬁ nitions.

5-9 Connector Deﬁ nitions

Required Connection

Required Connection

ATX Power 24-pin Connector

Pin Deﬁ nitions

Pin# Deﬁ nition Pin # Deﬁ nition

13 +3.3V 1 +3.3V

14 -12V 2 +3.3V

15 COM 3 COM

16 PS_ON 4 +5V

17 COM 5 COM

18 COM 6 +5V

19 COM 7 COM

20 Res (NC) 8 PWR_OK

21 +5V 9 5VSB

22 +5V 10 +12V

23 +5V 11 +12V

24 COM 12 +3.3V

Reset Button

Pin Deﬁ nitions (JF1)

Pin# Deﬁ nition

3 Reset

4 Ground

Power Button

Pin Deﬁ nitions (JF1)

Pin# Deﬁ nition

1 Power Signal

2 Ground

Secondary Power Connectors

JPW2 and JPW3 must also be con-

nected to the power supply. See the

table on the right for pin deﬁ nitions.

Main ATX Power Supply

Connector

The primary power supply connector

(JPW1) meets the SSI (Superset ATX)

24-pin speciﬁ cation. Refer to the table

on the right for the pin deﬁ nitions of

the ATX 24-pin power connector. You

must also connect the 8-pin (JPW3/

JPW4) processor power connectors to

your power supply (see below).

+12V 8-pin Power

Pin Deﬁ nitions

Pins Deﬁ nition

1 - 4 Ground

5 - 8 +12V

Power Fail LED

The Power Fail LED connection is

located on pins 5 and 6 of JF1. Re-

fer to the table on the right for pin

deﬁ nitions.

PWR Fail LED

Pin Deﬁ nitions (JF1)

Pin# Deﬁ nition

5 Vcc

6 Ground

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 95 96

Commentaires sur ces manuels

Pas de commentaire