Supermicro SuperServer 7036A-T Manuel d'utilisateur télécharger pdf (Page 89)

A-1

Appendix A: BIOS Error Beep Codes

Appendix A

BIOS Error Beep Codes

During the POST (Power-On Self-Test) routines, which are performed each time

the system is powered on, errors may occur.

Non-fatal errors are those which, in most cases, allow the system to continue

the boot-up process. The error messages normally appear on the screen.

Fatal errors are those which will not allow the system to continue the boot-up

procedure. If a fatal error occurs, you should consult with your system manufac-

turer for possible repairs.

These fatal errors are usually communicated through a series of audible beeps.

The numbers on the fatal error list correspond to the number of beeps for the

corresponding error.

BIOS Error Beep Codes

Beep Code Error Message Description

1 beep Refresh Circuits have been reset.

(Ready to power up)

5 short beeps + 1 long

beep

Memory error No memory detected in the

system

8 beeps Display memory

read/write error

Video adapter missing or with

faulty memory

1 continuous beep w/

Front Panel OH LED on

System Overheat 1 continuous beep with the

front panel OH LED on

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 95 96

Pas de commentaire

Supermicro SuperServer 7036A-T Manuel d'utilisateur Page 89