Supermicro 5018D-MF Manuel d'utilisateur télécharger pdf (Page 16)

2-2

SUPERSERVER 5018D-MF User's Manual

Choosing a Setup Location

• Leave enough clearance in front of the rack to enable you to open the front door

completely (~25 inches) and approximately 30 inches of clearance in the back

of the rack to allow for sufﬁ cient airﬂ ow and ease in servicing.This product is for

installation only in a Restricted Access Location (dedicated equipment rooms,

service closets and the like).

• This product is not suitable for use with visual display work place devices

acccording to §2 of the the German Ordinance for Work with Visual Display Units.

2-4 Warnings and Precautions

Rack Precautions

• Ensure that the leveling jacks on the bottom of the rack are fully extended to

the ﬂ oor with the full weight of the rack resting on them.

• In single rack installation, stabilizers should be attached to the rack. In multiple

rack installations, the racks should be coupled together.

• Always make sure the rack is stable before extending a component from the

rack.

• You should extend only one component at a time - extending two or more si-

multaneously may cause the rack to become unstable.

Server Precautions

• Review the electrical and general safety precautions in Chapter 4.

• Determine the placement of each component in the rack before you install the

rails.

• Install the heaviest server components on the bottom of the rack ﬁ rst, and then

work up.

• Use a regulating uninterruptible power supply (UPS) to protect the server from

power surges, voltage spikes and to keep your system operating in case of a

power failure.

• Allow the hot plug SATA drives and power supply modules to cool before touch-

ing them.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 119 120

Pas de commentaire

Supermicro 5018D-MF Manuel d'utilisateur Page 16