Supermicro 5018D-MF Manuel d'utilisateur télécharger pdf (Page 79)

Chapter 6: Advanced Chassis Setup

6-5

Serial ATA Drive Installation

The SATA drive is not hot-swappable, meaning system power must be turned off

before installing or removing.

1. First power down the system and then remove the top cover of the chassis as

described on page 6-7.

2. Unscrew the retention screw at the top center of the drive, then push the

drive tray out from the back until you can grasp and pull it out through the

front of the chassis.

3. Remove the drive from the drive tray.

4. To add a new SATA drive, install a drive into the tray with the printed circuit

board side facing down and so that the mounting holes align with those in the

tray.

5. Secure the drive to the tray with the four screws.

6. Replace the top cover when ﬁ nished. See Figure 6-3.

Note: the 5018D-MF can accommodate two internal SATA hard drives, one on

each side of the fans.

Warning: Enterprise level hard disk drives are recommended for use in Supermicro

chassis and servers. For information on recommended HDDs, visit the Supermicro

Web site at http://www.supermicro.com/products/nfo/storage.cfm

DVD-ROM Drive Installation

The top cover of the chassis must be opened to gain full access to the DVD-ROM

drive bay. The DVD-ROM must have a "slim" proﬁ le to ﬁ t into the 5018D-MF. If

you cannot remove the top cover with the system remaining in the rack, follow the

procedure below.

DVD-ROM Drive Installation

1. First shutdown the system and disconnect the AC power cable.

2. Make sure the system is supported from underneath then remove the front

bracket screws that secure the unit to the rack.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 119 120

Pas de commentaire

Supermicro 5018D-MF Manuel d'utilisateur Page 79