Supermicro CSE-808T-1200B Manuel d'utilisateur télécharger pdf (Page 29)

5-7

Chapter 5: Chassis Setup and Maintenance

Remove these screws

Installing the Motherboard

Review the documentation that came with your motherboard. Become familiar 1.

with component placement, requirements, precautions, and cable connec-

tions.

Disconnect the chassis from any power source and open the chassis cover.2.

Remove the expansion card brackets. To do this: 3.

A. Remove screw securing the expansion card bracket to the chassis.

B. Lift the bracket out of the chassis.

C. Repeat this process for the second riser card.

Lay the rst motherboard in the chassis aligning the standoffs4.

Secure the motherboard to the chassis using the rounded, Phillips head 5.

screws. Each motherboard requires ve screws. Do not exceed eight pounds

of torque when tightening down the motherboard.

Repeat steps 3 - 5 for the second side of the chassis.6.

Secure the CPU(s), heatsinks, and other components to the motherboard as 7.

described in the motherboard documentation.

Figure 5-7: Expansion Card Bracket

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 59 60

Pas de commentaire

Supermicro CSE-808T-1200B Manuel d'utilisateur Page 29