Supermicro 1012C-MRF Manuel d'utilisateur télécharger pdf (Page 64)

6-4

A+ Server 1012C-MRF User's Manual

Figure 6-2. System Cooling Fans

6-4 Drive Bay Installation/Removal

Accessing the Drive Bays

DVD-ROM/Serial ATA Drives: For installing or removing the DVD-ROM or SATA

drive, you will need to gain access to the inside of the server by removing the top

cover of the chassis. Note: Only a "slim" DVD-ROM will ﬁ t in the 1012C-MRF.

Serial ATA Drive Installation

The SATA drive is not hot-swappable, meaning system power must be turned off

before installing or removing.

First power down the system and then remove the top cover of the chassis as 1.

described on page 6-7.

Unscrew the retention screw at the top center of the drive, then push the 2.

drive tray out from the back until you can grasp and pull it out through the

front of the chassis.

Remove the drive from the drive tray.3.

To add a new SATA drive, install a drive into the tray 4. with the printed circuit

board side facing down and so that the mounting holes align with those in the

tray.

Secure the drive to the tray with the four screws.5.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 91 92

Pas de commentaire

Supermicro 1012C-MRF Manuel d'utilisateur Page 64