Supermicro 5017C-LF Manuel d'utilisateur télécharger pdf (Page 21)

Chapter 2: Server Installation

2-7

2-6 Checking the Drive Bay Setup

Checking the Drives

For servicing the hard drive, you will need to remove the top chassis cover. 1.

The SATA disk drive is located at the front of the chassis' interior.

If you need to install a SATA hard drive, please refer to the appropriate sec-2.

tion in Chapter 6.

Checking the Airﬂ ow

Airﬂ ow is provided by two 4-cm fans. The system component layout was care-1.

fully designed to promote sufﬁ cient airﬂ ow through the small 1U rackmount

space.

Also note that all power and data cables have been routed in such a way that 2.

they do not block the airﬂ ow generated by the fan.

Providing Power

The last thing you must do is to provide input power to the system. Plug the 1.

power cord from the power supply unit into a high-quality power strip that of-

fers protection from electrical noise and power surges. It is recommended that

you use an uninterruptible power supply (UPS).

Finish by pushing the power button on the control panel to power up the 2.

system.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 91 92

Pas de commentaire

Supermicro 5017C-LF Manuel d'utilisateur Page 21