Supermicro SYS-5038A-IL Manuel d'utilisateur télécharger pdf (Page 15)

Chapter 2: Installation

2-1

Chapter 2

Installation

2-1 Overview

This chapter provides a quick setup checklist to get your SuperWorkstation 5038A-IL

up and running. Following these steps in the order given should enable you to have

the system operational within a minimum amount of time. This quick setup assumes

that your system has come to you with the processor and memory preinstalled. If

your system is not already fully integrated with a serverboard, processor, system

memory etc., please turn to the chapter or section noted in each step for details on

installing speciﬁ c components.

2-2 Unpacking the System

You should inspect the box the system was shipped in and note if it was damaged

in any way. If the system itself shows damage you should ﬁ le a damage claim with

the carrier who delivered it.

Decide on a suitable location for the SuperWorkstation. It should be situated in

a clean, dust-free area that is well ventilated. Avoid areas where heat, electrical

noise and electromagnetic ﬁ elds are generated. You will also need it placed near

a grounded power outlet. Be sure to read the Rack and Server Precautions in the

next section.

2-3 Warnings and Precautions

• Ensure that the caster wheels on the workstation are locked.

• Review the electrical and general safety precautions in Chapter 4.

• Use a regulating uninterruptible power supply (UPS) to protect the workstation

from power surges, voltage spikes and to keep your system operating in case

of a power failure.

• Allow the power supply units and hot-swap SATA drives to cool before touch-

ing them.

• To maintain proper cooling, always keep all chassis panels closed and all SATA

carriers installed when not being serviced.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 121 122

Pas de commentaire

Supermicro SYS-5038A-IL Manuel d'utilisateur Page 15