Supermicro SYS-5038A-IL Manuel d'utilisateur télécharger pdf (Page 84)

7-2

SuperWorkstation 5038A-IL User's Manual

How to Start the Setup Utility

Normally, the only visible Power-On Self-Test (POST) routine is the memory test.

As the memory is being tested, press the <Delete> key to enter the main menu of

the AMI BIOS Setup Utility. From the main menu, you can access the other setup

screens. An AMI BIOS identiﬁ cation string is displayed at the left bottom corner of

the screen, below the copyright message.

Warning! Do not upgrade the BIOS unless your system has a BIOS-related issue.

Flashing the wrong BIOS can cause irreparable damage to the system. In no event

shall Supermicro be liable for direct, indirect, special, incidental, or consequential dam-

ages arising from a BIOS update. If you have to update the BIOS, do not shut down

or reset the system while the BIOS is updating. This is to avoid possible boot failure.

7-2 Main Setup

When you ﬁ rst enter the AMI BIOS Setup utility, you will enter the Main setup screen.

You can always return to the Main setup screen by selecting the Main tab on the

top of the screen. The Main BIOS Setup screen is shown below.

Main Advanced Boot Save & Exit

 : Select Screen

: Select Item

Enter: Select

+/- : Change Opt.

F1 : General Help

F2 : Previous Values

F3 : Optimized Defaults

F4 : Save & Exit

ESC : Exit

Set the Date. Use tab to

switch between Data elements.

Security

System Date [Wed 04/30/2013]

System Time [16:49:50]

Supermicro X10SAE

Version 1.00

Build Date

Memory Information

Total Memory 1024 MB (DDR3)

04/26/2013

Event Log

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 121 122

Pas de commentaire

Supermicro SYS-5038A-IL Manuel d'utilisateur Page 84