Supermicro SYS-5038A-IL Manuel d'utilisateur télécharger pdf (Page 44)

5-4

SuperWorkstation 5038A-IL User's Manual

5-4 Processor and Heatsink Installation

Warning: When handling the processor package, avoid placing direct pressure on the

label area of the fan.

Notes:

• Always connect the power cord last and always remove it before adding, re-

moving or changing any hardware components. Make sure that you install the

processor into the CPU socket before you install the CPU heatsink.

• If you buy a CPU separately, make sure that you use an Intel-certiﬁ ed multi-

directional heatsink only.

• Make sure to install the serverboard into the chassis before you install the CPU

heatsinks.

• When receiving a serverboard without a processor pre-installed, make sure that

the plastic CPU socket cap is in place and none of the socket pins are bent;

otherwise, contact your retailer immediately.

• Refer to the Supermicro web site for updates on CPU support.

Installing an LGA 1150 Processor

1. Press the load lever to release

the load plate covering the CPU

socket from its locked position.

2. Gently lift the socket clip to open

the load plate.

3. Hold the plastic cap at its north

and south center edges to remove

it from the CPU socket.

4. After removing the plastic cap,

hold the CPU at the north and

south center edges with your

thumb and index ﬁ nger.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 121 122

Pas de commentaire

Supermicro SYS-5038A-IL Manuel d'utilisateur Page 44