Supermicro SYS-5038A-IL Manuel d'utilisateur télécharger pdf (Page 99)

Chapter 7: BIOS

7-17



SATA Conﬁ guration

When this submenu is selected, the AMI BIOS automatically detects the presence

of the SATA Devices and displays the following items:

SATA Controllers

This item Enables or Disables the built-in SATA controllers on the motherboard. The

options are Enabled and Disabled.

SATA Mode Selection

This item selects the mode for the installed SATA drives. The options are IDE,

AHCI and RAID.

SATA RAID Option ROM/UEFI Driver (Available if the item above - SATA

Mode Select is set to AHCI or RAID)

Select Enabled to use the SATA RAID Option ROM/UEFI driver for system boot.

The options are Enabled and Disabled.

If the item above -SATA Mode Select is set to AHCI, the following items are

displayed:

Serial ATA Port 0~ Port 5

This item displays the information detected on the installed SATA drives on the

particular SATA port.

• Model number of drive and capacity

• Software Preserve Support

Port 0 ~ Port 5 Hot Plug

This feature designates the port speciﬁ ed for hot plugging. Set this item to En-

abled for hot-plugging support, which will allow the user to replace a SATA disk

drive without shutting down the system. The options are Enabled and Disabled.

Port 0 ~ Port 1 SATA Device Type

This feature conﬁ gures the selected SATA port to support either a solid state

drive or hard disk drive. The options are Hard Disk Drive and Solid Sate Drive.

Port 0 ~ Port 5 Spin Up Device

On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-

SET initialization sequence to the device. The options are Enabled and Disabled.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 121 122

Pas de commentaire

Supermicro SYS-5038A-IL Manuel d'utilisateur Page 99